This reverts commit 02c7904d.

Change-Id: I350a0585889282790899d01d0a91d5699d125615
Signed-off-by: Sanjay Dwivedi <sanjaykd@codeaurora.org>

Add PTP config for open-avb.

Change-Id: I2ae30c1b711d8dda5c6a6837e3aa6eb1a5f8c022
Signed-off-by: Jayadev K <jayak@codeaurora.org>

Enable LZ4 compression algorithm support so that zram can be configured to
use it.

Change-Id: Ibd83e370cd7a76d3675e86d4630db5ff0628eb89
Signed-off-by: Liam Mark <lmark@codeaurora.org>

Client votes for each BCM device are required to be logged,
so add a new ftrace event to log the same.

Change-Id: I5a7585c8252a5285219471af07bf6fe9486a22ef
Signed-off-by: Odelu Kukatla <okukatla@codeaurora.org>

Coalescing close frame command allocated multiple times during
every suspend instead allocate command payload once in post init.

Change-Id: Iba83a7ff032707739d0a3b006ee6fa5245ac3857
Signed-off-by: Ashok Vuyyuru <avuyyuru@codeaurora.org>

When CPU load is high IPA buffer replenish WQ scheduling got delayed
because of that not able to replenish the descriptors. Add changes to
hold the clock until replenish the minimum number of descriptors.

Change-Id: Iea79dcaa90d12fc4324522ba2c63dfcdfded2f90
Signed-off-by: Ashok Vuyyuru <avuyyuru@codeaurora.org>

It is observed that commit 91480019 ("power: smb5: Fix OTG random
disconnection issue") causes an increase in bottom current when a Type-C
sink is connected. Fix this issue by disabling the pulldown on USBIN
whenever a Type-C sink or source is attached, and enabling it when it
has been detached.

CRs-Fixed: 2535589
Change-Id: If2a2ef612588464f1f0401a1b93ca3a0baacd4dc
Signed-off-by: Guru Das Srinagesh <gurus@codeaurora.org>
Signed-off-by: Anirudh Ghayal <aghayal@codeaurora.org>

LE CPE device do not have audio codec connected.

CRs-fixed: 2552672
Change-Id: I116c106db46b632940383ae89f3a3004f9b64fed
Signed-off-by: Asish Bhattacharya <asishb@codeaurora.org>

Update drive strength value in pinctrl for QUAT and QUIN
TDM interfaces to avoid noise caused by signal overshoot
or undershoot on clock, sync and data lines to A2B on
x150 automotive platforms.

Change-Id: Iac2b14c25faced4ad42fa3677e4a8826e7540a03
Signed-off-by: Derek Chen <chenche@codeaurora.org>

Tools can query the active transport being used by diag using the
transport query command and then configure the qdss trace sink.

Change-Id: I549090a6b3437d5ddc86cddd28baecbd4d1ac5ad
Signed-off-by: Sreelakshmi Gownipalli <sgownipa@codeaurora.org>

NPU needs to vote MSM_BUS_SLAVE_CLK_CTL bus slave to work properly.
When handling IPCC interrupts from apps, there may be a NOC timeout
error if apps enters into LPM without voting for minimum bw vote.
CNOC needs to be voted to make sure IPCC register write succeeds.

Change-Id: I64ba7cc86ebe16f1a5eb6aa13b0656fd81bf814b
Signed-off-by: Da Hoon Pyun <dpyun@codeaurora.org>