Tags

Add new set_mode phy ops

Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>

Linux 4.7-rc6

regulator: Fixes for v4.7

Two small fixes for the regulator subsystem - one fixing a crash with
one of the devices supported by the max77620 driver, another fixing
startup for the anatop regulator when it starts up with the regulator in
bypass mode.

ASoC: Fixes for v4.7

A small clutch of hardware specific fixes for various ASoC devices, all
small individually and important if you have that device but not
otherwise.

ASoC: Add private data for HDMI CODEC callbacks

Allow the HDMI CODECs to get private data passed in in callbacks.

IOMMU Fixes for Linux v4.7-rc5

Three fixes:

	* Fix use of smp_processor_id() in preemptible code in the IOVA
	  allocation code. This got introduced with the scalability
	  improvements in this release cycle.

	* A VT-d fix for out-of-bounds access of the iommu->domains
	  array. The bug showed during suspend/resume.

	* AMD IOMMU fix to print the correct device id in the ACPI
	  parsing code.

16.06 release

regulator: pwm: Support GPIO enables

Allow PWMs to control an external GPIO enable, needed by some systems to
propagate the output.

Android Wear 5.1.1 Release 0.24

Android Wear 6.0.1 Release 0.22

Just two small fixes
 * fix mesh peer link counter, decrement wasn't always done at all
 * fix ethertype (length) for packets without RFC 1042 or bridge
   tunnel header

A single fix:
 * fix mesh peer link counter, decrement wasn't always done at all

Qualcomm Device Tree Changes for v4.8

* Reverse BAM dma node reverts
* Add BAM remote control options for affected platforms
* Enable peripherals on APQ8074 dragonboard
* Enable PMA8084 pwrky
* Fix PMIC reg entries by removing unnecessary size element
* Add SCM binding and support for all currently supported boards
* Add Qualcomm WCNSS binding documentation
* Rename db600c to SD_600eval and add peripheral nodes
* Remove gpio key entry from Nexus7
* Add APQ8060 based dragonboard and associated peripherals
* Add ARMv7 PMU for IPQ4019
* Update smem state cells to match documentation

Qualcomm ARM64 Updates for v4.8

* Enable assorted peripherals on APQ8016 SBC
* Update reserved memory on MSM8916
* Add MSM8996 peripheral support
* Add SCM firmware node on MSM8916
* Add PMU node on MSM8916
* Add PSCI cpuidle support on MSM8916

Qualcomm ARM Based Driver Updates for v4.8

* Rework of SCM driver
* Add file patterns for Qualcomm Maintainers entry
* Add worker for wcnss_ctrl signaling
* Fixes for smp2p
* Update smem_state properties to match documentation
* Add SCM Peripheral Authentication service
* Expose SCM PAS command 10 as a reset controller